![]() The other thing: I wouldn't trust those drywall anchors you show in your picture. Many companies make separate versions of their products for the US and for everybody else in the world. I'm not sure what the European standard is, but you can be sure it's in centimetres, not inches! This is why you're extremely unlikely to line up more than one hole. We have a bunch of LACK shelves all over the house, and my fiancee also uses them in her office.Ī couple of things: American construction uses studs spaced "16 inches on center" - this means that the studs are 16 inches apart, measuring from the center of one to the center of the next. The funny thing is I always loved the way these looked. I drilled a pilot hole with the drill bit and then twisted the screw into the wall.Īfter the back plate was completely installed I slid on the shelf, attached it to the back plate with the two small screws that IKEA did supply for this purpose. Because my studs were metal not wood, I had to go back to Pleasant's to buy metal screws that work with wood and metal. The side of the shelf attached to a wall stud does not need anchors. ![]() I placed the back plate up and inserted the screw into the anchor and drove it in until it felt secure. Then I just had to twist the anchor into the drywall until it was flush with the wall. I inserted the Phillips Head bit on my screwdriver into the hole of the anchor and pressed the point into the wall. The anchors would be used on the side not attached to a stud. The LACK shelf is actually a shell that is slid over this plate and two small screws attach the shelf to the back plate. I was now ready to attach the back plate to the wall. However, I waited to put the shelves up on a weekend when I would have a whole day to deal with anything else that might come up. After I don't know how many tries, on how many days, I had pencil dots marking some fairly consistent studs. However, no matter how many times I read the directions I kept coming up with different locations for the studs in my wall. I bought the highly recommended Black & Decker BullsEye laser and stud sensor. Target has some of the same tools for less money (Black & Decker, McCullouch, etc.).Small hardware stores beat the Big Box stores (Lowe's, Home Depot).Nylon self-drilling anchors for drywall also known as wallboard (see picture at top of post)īlack & Decker 6V PivotPlus rechargeable screwdriver/drillģ/8-inch drill bit (came with the PivotPlus) The trips were to buy these following items:īlack & Decker BullsEye level and stud finder I have receipts from 4 trips, but then there were the fruitless scouting missions here and here. of trips to a store in one month for this project: I found I had metal studs instead of wood ones, which changed what type of anchor I needed. (That is why this shelf is notorious for faulty installation and stability failure.) IKEA does not provide the hardware or even suggest what type you need for this item. I described to them what I was doing and they recommended the right screws and anchors for the project.ĭifficulties:Had to find the placement of studs in my wall The people who work there actually know what they're doing when it comes to DIY. It is a chain but much smaller than Home Depot or Lowe's. I went to my local small hardware store, Pleasant's hardware. Well, I was thoroughly justified in putting off installing this shelf for so long. After two years, I finally decided to tackle the IKEA LACK shelf.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |