![]() ![]() Disabled the serial console, using "sudo raspi-config", set enable_uart=1 in /boot/config.txtĢ. Doing the same with sudo minicom worked, but is saves the dlf to the root user. The device appears connected via lsusb, however I cannot send and receive data. Minicom -b 9600 -D /dev/ttyAMA0, but the results are the same.įollowing the posts on this forum, I had made sure the following:ġ. The best FreeBSD alternative is CuteCom, which is both free and Open Source. The default port is a non-existing /dev/usb8 After having set the port to /dev/ttyUSB0 i wanted to save the settings to dlf, but it failed due to missing permissions. 7 OS: Linux Mint 19 Tara (also tested on Ubuntu 18.04 LTS and Ubuntu 14.04 LTS) Kernel: 4.15.0-20-generic I have a USB-Serial adapter with the PL2303X chip to connect hardware to a Linux host. This could become a root-compromise considering that uucp has write access to several programs (such as minicom, cu and ecu on FreeBSD 3.3) and could. _in_Ubuntu for serial device /dev/ttyAMA0 (Bps/Par/Bits - 9600 8N1, Hardware and Software Flow Control set to "No")įor troubleshooting to ensure that there are no hardware issues (I tried with two different Pi3 also) with the MAX3232 adapter or the Pi3 itself, I tried to connect the UART TXD and RXD pins - 8 & 10 and was trying minicom again on the Pi. Minicom status is shown as offline and no action is happening on the key presses. Since even after following the simple steps at, I am not able to get anything appear on the terminal screen. MINICOM (1) Version 2. As a newbie, I am trying to connect a serial device to the Raspberry Pi3 using a MAX3232 adapter (RS232 to TTL). FreeBSD 11.x on Ubiquiti EdgeRouter Lite Update 7: New image available for 11.0-RELEASE-p8 Update 1: New version of the build script creates more inodes in root filesystem. git: 72811e6606a8 - main - comms/minicom: update to 2.8.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |